Updated Nov 22, 2026· 8 min read

Key takeaways

  • Compare the best trailer fender lights for wide trailers — dual-face LED pedestal lights with amber front and red rear, plus sealed and stud-mount picks.

Disclosure: As an Amazon Associate, I earn from qualifying purchases.

Our top pick: Partsam 4-Inch Round Double Face 48 LED Pedestal Fender Lights. Runner-up: Nilight Double-Face Fender Pedestal Lights.

A trailer fender is the widest point on most utility, boat, and enclosed trailers, so a light mounted there is the first thing a passing driver sees at night. A fender light marks the trailer’s full width from the side, telling other drivers where your trailer ends before they try to pass it.

Fender lights are not side marker lights. A side marker is a small flush lamp that marks a point along the trailer body. A fender light is a larger pedestal or surface-mounted lamp on top of the fender itself, usually with two faces: amber forward and red rearward. This guide covers five of them, all LED and all with a verifiable Amazon listing.

How to Choose

Amber front, red rear is the rule, not a style choice

On a trailer, amber faces forward and red faces rearward. That color split is a legal requirement in most places, not a decoration, so check your local rules before you order. A dual-face light enforces the rule by construction.

LED lasts longer, incandescent is cheaper to replace

Every pick in this guide is LED. An LED fender light draws less current than an incandescent bulb, and it survives vibration far better than a filament.

Sealed housings survive rain and road spray

A fender light lives in the worst spot on a trailer: low, exposed, and directly in the path of spray thrown up by the tire. Look for a sealed housing and a stated water-resistance rating. IP65 means the light resists water jets from any direction, while IP67 means it can survive brief immersion, which matters for boat trailers that get dunked at the ramp.

Stud mount, surface mount, or grommet mount

Pedestal fender lights usually mount with one or three studs through a drilled hole in the fender, with a nut and washer underneath. That is the most secure mount for a tall pedestal light, but it means drilling a 12 mm hole. Surface-mount bullet lights screw to the fender with no large hole, and grommet-mount lights press into a round hole with no screws.

A light cannot fix a broken ground or a blown fuse

If a fender light stays dark, the problem is usually not the light. Test the ground first: clean the ground connection on the trailer frame, check the fuse in the tow vehicle, and test for voltage at the light with a test lamp. A new light wired into a corroded ground will stay dark exactly like the old one did.

The 5 Best Trailer Fender Lights

1. Partsam 4-Inch Round Double Face 48 LED Pedestal Fender Lights

Specs

  • 48 LEDs per light: 24 amber on one face, 24 red on the other
  • Chrome housing with a single stud mount
  • Operating voltage: 10 to 30 volts DC
  • DOT compliant for street-legal lighting
  • Sealed housing with a mini reflector behind each diode

Partsam’s 4-inch round pedestal light is the most complete fender light in this guide. Each light carries 48 diodes, split evenly between amber and red, and each diode sits behind its own mini reflector, which spreads the light wider than a flat lens would. The three-wire setup is standard: white for ground, black for the low-brightness running light, and red for the high-brightness stop, turn, and brake functions. It works on 12-volt and 24-volt trailers and is DOT compliant for street-legal lighting. The trade-off is size: it can look oversized on a narrow fender.

2. Nilight Double-Face Fender Pedestal Lights

Specs

  • 14 LED diodes per light: 7 amber facing forward, 7 red facing rearward
  • Extended bracket housing for neater wire routing
  • Pre-wired with a three-wire connection
  • Mounts on top of the fender as an add-on pair
  • Dual-face design for front and rear clearance marking

Nilight’s double-face fender lights are the add-on pick in this guide: a pair of pedestal lights that mount on top of the fenders to mark the trailer’s widest points, rather than a full lighting package. The extended bracket housing is the feature that matters here: it gives the wires a protected channel from the light down to the fender, so the wiring stays out of the spray path and out of sight. The limitation is scope: two fender lights only. They do not replace tail lights, a wiring harness, or a full marker-light package, so buy them as an addition to working rear lighting, not as a substitute for it.

3. BukNikis Double Face 39 LED Pedestal Fender Lights

Specs

  • 39 LEDs per light in a double-face pedestal design
  • Three-stud mount for a secure fit on the fender
  • Amber and red faces for turn, brake, stop, and marker functions
  • Listed for trailers, towing and boat use, RVs, and heavy-duty trucks
  • Sold as a driver and passenger side pair

BukNikis takes a different approach to the same problem: a 39-LED double-face pedestal light with a three-stud mount instead of a single stud. Three studs spread the load across the fender, which matters on a tall pedestal light that catches wind and vibration at highway speed. A single-stud light can work loose over time if the nut backs off; a three-stud mount stays put even if one fastener loosens. The trade-off is the install: three holes instead of one means more drilling, so use the light itself as a template and drill carefully.

4. OGATOO Square 52 LED Double-Face Pedestal Fender Light

Specs

  • 52 LEDs per light in a square double-face pedestal design
  • Three-stud mount with a 12-volt IP65 waterproof rating
  • Amber and red faces for stop, turn, tail, and signal functions
  • Square housing for trailers, semi trucks, and towing use
  • Sold as a two-piece set

OGATOO’s square pedestal light is the brightest pick in this guide by diode count, with 52 LEDs in a square housing that reads as a modern alternative to the round pedestal shape. The 12-volt rating is the one limitation to note: this light is built for standard 12-volt trailer systems and is not listed for 24-volt use, unlike the Partsam pick above.

5. Partsam Bullet LED Trailer Fender Lights

Specs

  • Bullet-style LED fender light pair: amber front, red rear
  • DOT certified for trailers over 80 inches wide
  • Operating voltage: 12 volts DC, 5 watts
  • Left and right lamps for the front and rear of the fender
  • Compact surface-mount design for tight fender space

Partsam’s bullet fender lights are the compact pick in this guide, and they solve a different problem from the pedestal lights above. A pedestal light needs a wide flat spot on the fender and a drilled hole for the stud. A bullet light screws to the fender surface and takes up far less room, which makes it the right choice for a narrow fender, a curved fender, or a trailer where a tall pedestal would snag on cargo or a ramp. The pair is sold as left and right lamps with amber facing forward and red facing rearward, and the listing states DOT certification for trailers over 80 inches wide. The trade-off is brightness: a bullet light has fewer diodes and a smaller lens than a pedestal light. Note that this listing is sold through the Canadian storefront, so confirm shipping and availability before ordering.

Usage and Buying Notes

Measure the fender before you order anything. A pedestal light needs a flat spot at least as wide as its base, and a bullet light needs a flat spot for its bracket. Hold the light in place before drilling, and check that the tire clears the light at full suspension travel.

Wire color is nearly universal across the picks in this guide: white is ground, black is the low-brightness running light, and red is the high-brightness stop, turn, and brake function. Confirm the colors on your trailer’s existing wiring before connecting.

Test the ground before you blame the light. Clean the ground connection on the trailer frame with a wire brush, check the fuse in the tow vehicle, and test for voltage at the light with a test lamp. A corroded ground is the most common cause of a dark fender light. Check your local rules for color and placement as well: amber forward and red rearward is the standard split, but some jurisdictions add requirements for trailers over 80 inches wide.

Frequently Asked Questions

Are fender lights the same as side marker lights?

No. A side marker is a small flush lamp that marks a point along the trailer body. A fender light is a larger pedestal or surface-mounted lamp that sits on top of the fender, usually with amber facing forward and red facing rearward, and it marks the trailer’s full width.

Do I need one fender light or two?

Two, one per fender. A single fender light only marks one side of the trailer, which defeats the purpose. The picks in this guide are sold as left and right pairs for that reason.

Can I replace an incandescent fender light with an LED pedestal light?

Yes, as long as the mounting hole and the wire colors match. LED pedestal lights use the same three-wire setup as most incandescent fender lights: ground, running light, and stop or turn.

Why does my new fender light stay dark?

Test the ground first. Clean the ground connection on the trailer frame, check the fuse in the tow vehicle, and test for voltage at the light with a test lamp. A corroded ground or a blown fuse is far more likely than a faulty new light.

A dual-face light with amber forward and red rearward matches the standard color split for trailer clearance lighting, and several picks in this guide are DOT compliant. Street legality still depends on the whole setup and on local rules.

Conclusion

A fender light is a small purchase that does an outsized job: it marks the widest point of the trailer so other drivers can see where your load ends. The Partsam 4-inch round pedestal light is the most complete pick, with 48 diodes and a DOT-compliant chrome housing. The BukNikis and OGATOO pedestal lights trade a round shape for a secure three-stud mount, and the Partsam bullet lights fit fenders where a pedestal simply will not go.

A
Autozane Editorial Team
We compare specs, materials and verified owner reviews before a product earns a spot. Rankings are never paid.
Affiliate disclosure. As an Amazon Associate we earn from qualifying purchases at no extra cost to you. Prices accurate as of the date shown.
Best Trailer Fender Lights: 5 Picks for Wide…Check price on Amazon

More from Amazon

Programs that pair well with the guide above. Offers and eligibility are set by Amazon and may change.

Amazon Prime

Free shipping on eligible items, Prime Video and more. Eligible new members can start with a free trial.

Start a Prime free trial
Audible

Audiobooks and podcasts to listen to on the go. Eligible new members can start with a free trial.

Try Audible free
Amazon Music Unlimited

Ad-free music streaming. Eligible new subscribers can start with a free trial.

Try Music Unlimited free
Amazon Business

A free business account with business pricing and bulk-buying tools for work, shop or home office.

Create a business account

As an Amazon Associate we earn from qualifying purchases.